Your position: Home / Solutions to Problems

Solutions to Problems

Why is the printed model out of the print platform?It's not printed at all?

3D printer model construction relies on the accumulation of layers of filament, which plays a very important role in the stability of the bottom.
You can adjust the print platform through the "leveling" option so that the first layer of the model perfectly adheres on the print platform. you can refer to User Guide of leveling operation to adjust the print platform, the first layer of the printing effect may refer to the image below to get to know your leveling effect is perfect or not.


Why does the nozzle produce no filament when printing? Thin filament?

Due to a variety of reasons, it often occurs that filament cannot be extruded when printing or filament loading.At this time, it is necessary to unclog and clean the residual filament of filament loading path manually to ensure the smooth filament inlet channel.
Firstly, you need to disassembly the filament feeding motor of the nozzle to expose the filament feed hole below.Then turn on the preheat function on the device and heat the nozzle to a temperature high enough to melt the filament and hold it for a short time.Finally, press the filament inlet channel with a 1.5mm unclogging pin in the kit provided with the device to extrude the filament from the nozzle.

What should I do if my printing platform is dirty and bumpy?

When the build tape on the printing platform is dirty and damaged, the build tape needs to be replaced. First, tap "preheat" function in the equipment to heat the build plate to 45°-60° (high temperature is better,  45°is good to prevent burns ), keep it for a few minutes until the glue under the build tape softens, then remove the old build tape along the corner, and use alcohol to remove the residue on the build plate. After wiping up, put on the new build tape and smooth it out.

Why can't my model be read by the printer?

Apollo3D Saturn printer can be applied to all open source slicing software, but the parameters of Apollo3D Saturn printer should be set on the software first to ensure the quality and reliability of printing. The parameter setting of slicing software in the USER GUIDE.



Links:jewelry showcaseABB BOARDergonomic baby carriervibratorsaluminium cutting oilaluminum core composite panelgrillroller foot sewing machinevariac transformerdisposable vape factorytoupeekitchen supliesled grow lampscratch win cardcoil tipper